![]() Ensure that nearby APs are using different channel, when possible.When configuring the 2.4 GHz radio, only select from channels 1, 6, and 11.If interference levels are similar, prioritize picking the channel with the least utilization.This means selecting the highest magnitude numbers (e.g., -90 dBm is preferred to -80 dBm). Pick the channel with minimal interference for each AP's 2.4 GHz and 5 GHz radios.Perform a radio-frequency (RF) scan of your environment in UniFi Devices > select an AP > Insights > Scan Channels.Clients should have a minimum signal strength of -60 dBm, though -50 dBm or better is recommended for maximum performance.Signal Strength is shown in the WiFi Insights tab, or by clicking on a client device.Increase your client's signal strength by moving it closer to the nearest AP or adding an additional AP nearby.Set the Transmit Power to Auto for each AP's 2.4 GHz and 5 GHz radios.Individually configured in UniFi Devices > select an AP > Settings.These changes will not be applied to any AP Exclusions listed. Globally configured under Settings > WiFi > Global AP Settings.The 2.4 GHz radio should remain on 20 MHz to avoid excessive interference. Increase the channel width to 80 MHz or 160 MHz for each AP's 5 GHz radio.If you are looking for information to improve your wireless connectivity, click here. If you experience degraded connection quality (i.e., high latency or wireless disconnections), then you should consider reverting any changes and using UniFi's default settings which prioritize wireless connectivity, as opposed to speeds. This article explains the best practices for optimizing WiFi speeds. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |